Quake3World.com https://www.quake3world.com/forum/ |
|
Curved stairs? (not spiral) https://www.quake3world.com/forum/viewtopic.php?f=10&t=51009 |
Page 1 of 1 |
Author: | AndehX [ 04-21-2015 04:28 AM ] |
Post subject: | Curved stairs? (not spiral) |
I can't believe I can't find a tutorial on this anywhere... The only tutorial I can find is for a spiral staircase, like this http://www.katsbits.com/tutorials/idtec ... stairs.php I want stairs like this: Anyone know the best way to make stairs like that? |
Author: | cityy [ 04-21-2015 04:36 AM ] |
Post subject: | Re: Curved stairs? (not spiral) |
Create 2 patch bevels for guidance and fiddle it together using the edge tool to align the brushes to the bevels. |
Author: | AndyW [ 04-21-2015 06:15 AM ] |
Post subject: | Re: Curved stairs? (not spiral) |
I do it this Way: 2 Patches for guidance. Then i use the clipper to cut the stairs. Im not good in writing tutorials but i hope this few pictures will help you! Also i found this link: http://panjoo.tastyspleen.net/curvedsta ... index.html |
Author: | AndehX [ 04-21-2015 06:53 AM ] |
Post subject: | Re: Curved stairs? (not spiral) |
Yeah I figured using patches as guidance was the best way. Cheers |
Author: | AndehX [ 04-21-2015 10:58 AM ] |
Post subject: | Re: Curved stairs? (not spiral) |
Done |
Author: | AndyW [ 04-22-2015 11:48 AM ] |
Post subject: | Re: Curved stairs? (not spiral) |
To me its always Pain to fit Trim to those round stairs! |
Author: | KittenIgnition [ 04-22-2015 05:42 PM ] |
Post subject: | Re: Curved stairs? (not spiral) |
I would have just used a curve generator and modified it a bit |
Author: | AndyW [ 04-22-2015 06:16 PM ] |
Post subject: | Re: Curved stairs? (not spiral) |
Hmmm.. Generators.. Hmmm... |
Author: | CZghost [ 04-24-2015 06:32 AM ] |
Post subject: | Re: Curved stairs? (not spiral) |
AndehX wrote: The Edge forever |
Page 1 of 1 | All times are UTC - 8 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |