Quake3World.com Forums
     Level Editing & Modeling
        is it possible to time delay shader parameters?

Post new topicReply to topic
Login | Profile | | FAQ | Search | IRC

Print view Previous topic | Next topic 
Topic Starter Topic: is it possible to time delay shader parameters?

Joined: 22 Jun 2014
Posts: 47
PostPosted: 07-28-2017 09:25 AM           Profile Send private message  E-mail  Edit post Reply with quote


I'm using scroll and deformvertexes move to simulate snow. The issue is that all brushes move in unison (they reach the end of the move and change direction simultaneously). I was wondering if I could delay deformvertexes move for one set of brushes so that they begin their move when the other set is in the middle of its own. Is this possible purely shader-side? thanks!

EDIT: never fails that once I make a post I figure it out shortly after. "phase" is what I was looking for. I was thrown off because I didn't understand it fully and was testing values like 0, .5 and 1 when really .25 or .75 is what I needed.


Quake3World.com | Forum Index | Level Editing & Modeling

Post new topic Reply to topic

Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group