Page 1 of 1
vq3 forcemodel question
Posted: Mon Oct 24, 2005 9:28 pm
by dzjepp
So I have this in my autoexec.cfg
seta cg_forcemodel "1"
seta model "keel/red"
seta headmodel "keel"
seta team_model "keel"
seta team_headmodel "keel"
And in tdm/ctf everyone is sarge. =o
In osp/cpma you can use cg_enemymodel "keel/pm" for enemies. Isn't the above the vq3 variation for getting custom models to appear on enemies?
Posted: Mon Oct 24, 2005 9:33 pm
by ^misantropia^
cg_forcemodel 1 in VQ3 sets all player models to Sarge. There's no avoiding that unless you make your own PAK that replaces the sarge model with keel. I've got one if you want. Doesn't work on pure servers, obviously.
Posted: Mon Oct 24, 2005 9:39 pm
by dzjepp
Ahh and if I set it to 0, will the 'teammodel' command work? I'd imagine that would only force for the players team?
Does the same thing happen in osp/cpma, when you have cg_enemymodel disabled, but the other commands like above, does it still force everyone to sarge?
Posted: Tue Oct 25, 2005 7:31 am
by corncobman
In vq3 teammodel only changes your model in teamplay, not everyone else's. It's either force everyone to sarge or none. In non teamplay games forcemodel forces everyone's model to yours. Dunno about OSP/CPMA.
Posted: Tue Oct 25, 2005 10:50 am
by ^misantropia^
dzjepp wrote:Does the same thing happen in osp/cpma, when you have cg_enemymodel disabled, but the other commands like above, does it still force everyone to sarge?
In CPMA, it sets all player models to your own.