Q3A won't load a map anymore

Post by **Kammesennin** » Mon Apr 02, 2007 4:34 am

I've been working on a map for some time now... been using Q3Radiant for the most part. Just started working in GTKRadiant and compiled the map and suddenly Q3 does't want to load it.
It goes through the normal procedure for loading a map up until it goes to load the BSP file... then it spits out an error about the BSP file not found in the maps folder... I check the maps folder and lo and behold the friggin' thing is there... can anybody tell me what the hell is going on here?

Post by **leilei** » Mon Apr 02, 2007 5:31 am

sv_pure 0

also sv_pure 0

i can not stress this enough
sv_pure 0

Post by **AmIdYfReAk** » Mon Apr 02, 2007 2:47 pm

pfsht, i dont know what leilei is talking about... but sv_pure 0 is what you are looking for

Post by **Kammesennin** » Mon Apr 02, 2007 3:26 pm

strange, it must've reset itself... damned thing, i should've known lemme go try that. thanks guys

EDIT: Yep, that was it, thanks again.

...feel so stupid for that one, lol.